I tested de-interlacing in VLC and I could see the interlacing artifacts go away. I'm probably just missing something simple.Īlso yeah the footage is definitely interlaced when I copied it, as right now it's just a raw uncompressed AVI because I wanted to make sure my work flow was setup properly. I've been using this thread a lot for info which KarMa posted in, but I was unable to reproduce the steps.
DIAMOND VC500 SNAPSHOT HOW TO
I tried using MeGUI, but I couldn't quite figure out how to use it. However, one of the reasons why I was going with my previous method is I was having trouble figuring out how to trim the edges of my video.
![diamond vc500 snapshot diamond vc500 snapshot](https://www.diamondmm.com/wp-content/uploads/2018/01/VC500_4opt.jpg)
![diamond vc500 snapshot diamond vc500 snapshot](http://iapoon.com/wp-content/uploads/images/41vQ9PHUslL.jpg)
Some will probably ask why the picture doesn't fill the whole screen. Yeah after reading a bit more and thinking about it I think cropping to 704x480 and then resizing to 4:3 is the best bet especially considering that I do plan on giving this video out and sharing it to family members who are not at all going to be interested about aspect ratios or anything like that. I am probably overthinking this and the ffmpeg method is probably close enough to the original source when viewed on a modern screen, but if even just for my own curiosity I'd like to make sure I am doing it properly. Is this normal? From what I've seen there shouldn't be a border at the top and bottom, but does it even matter? If it does how should I deal with it? Let me explainĪs you can see, there's a single 1 pixel border at the top along, a 2 pixel border on the bottom with what I think is supposed to be 16 pixel borders on the edges, but depending on how I count it can be off by a bit. Not only that, but a lot of what I'm reading about with how to scale analog standard definition sources to monitors doesn't seem to translate fully to my specific case because most of it is dealing with sources that have more defined resolutions like consumer DVDs, while my source seems to have a few quirks so I'm not sure how to translate the aspect ratio. I've used ffmpeg to convert the video to 4:3 aspect ratio using the commandĬode: mp4box test.avi -out test3.mkv -par 1=10:11 but I just keep getting "Error: Bad Parameter" and I've been unable to get around that.
![diamond vc500 snapshot diamond vc500 snapshot](https://i5.walmartimages.com/asr/9d80c20f-b10b-41ea-9831-ebc21e3df9fc.7ea9eba3c3577c0ead3851adc4488c88.jpeg)
So I understand that standard definition horizontal pixels were wider than vertical pixels so this is where I'm a bit stuck. The quality looks great, however I know that VHS is 4:3 aspect ratio and 720x480 is 3:2, so I went down the rabbit hole of aspect ratios and learning about DAR and PAR and I'm still a little confused about the subject, and while all this stuff doesn't really matter for my purposes, it's been fun learning about it so I'd like to do it properly. I recorded some test footage with VirtualDub2 with the uncompressed format at 720x480 which is the native resolution of the capture card. This forum has been tremendously helpful in answering nearly all of my questions about setting up converting my families old vhs tapes to digital, however I'm still a little stuck on the aspect ratio part.įirstly, I'm using a Diamond VC500 with composite cables connected to my VCR and the video itself was recorded in 1992.